BIBLIOTEKA Sculpt Jelly Gel № 04 Nude – Warm Beige, 20 ml
NUDE – a warm beige shade for natural-looking finishes in the nude color palette.
It creates a soft, even tone on the nail plate and blends harmoniously with various skin tones.
SCULPT GEL (jelly) – a modeling hard gel with a jelly-like texture for use in situations where complete control over the material is essential.
Thanks to its high viscosity, the material does not spread during application, allowing you to fully control the shaping and architecture of the nail without smudging or rushing.
Purpose:
- strengthening natural nails
- length extension
- shaping on lower and upper forms
- repairing and restoring corners using the “sidewall” technique
SCULPT GEL
Control in every move
A line of gel-jelly products for those who value control over the material at every stage of the process
Benefits:
- A jelly-like texture for maximum control over the material.
- Does not spread during application and retains its shape until polymerization.
- Comfortable, unhurried application.
- Suitable for strengthening, shaping, and correction.
- Allows you to work on multiple nails at the same time.
- High strength after curing.
- Low heat generation during polymerization.
- Compatibility-works with bases/primers from most systems.
- Safe formula: TPO-free
Technical Specifications:
- Type: modeling gel-jelly
- Consistency: very thick (jelly-like)
- Self-leveling: low, thixotropic
- Elasticity: moderate
- Hardness: high
- Dispersion: a sticky layer remains after polymerization
- Curing: LED – 60-90 sec. / UV – 120-180 sec.
- Volume: 20 ml
Recommendations for use:
- Prepare the nail plate (chemical/mechanical preparation).
- Apply a thin layer of SCOTCH BASE / RUBBER BASE using rubbing motions.
- Apply SCULPT GEL, shaping the desired design.
- Curing: LED – 60-90 sec. / UV – 120-180 sec.
- Remove the dispersion layer; if necessary, lightly buff the nails.
- Apply color or top coat according to the procedure.
Warnings:
Avoid contact with skin. Store in a tightly closed container at a temperature between +5°C and +25°C. Keep away from light and out of reach of children. This material is sensitive to UV/LED light-do not leave it exposed to lamp light or sunlight while working or filming to prevent premature curing. Use only as directed.
